Nortel Networks 1000M - Manual (Page 430)

430 Changing preprogrammed data
LD 14
REQ NEW
TYPE aaa M where "aaa" = the type of trunk that you are
creating (TIE, COT, WATS, and so on)
MODL YYY where "YYY" = the model number of the trunk
that you are creating (between 1–127)
XTRK a...a Where a...a = XUT, XEM, XCOT, XDID
This prompt only appears when you define the
first model in a group. Each group consists
of 16 consecutive model definitions. (Refer to
the group boundaries listed below.) Once the
first model in a group is defined, the remaining
model numbers in the group(s) are assumed
to be of the same type.
Group boundaries are as follows:
1–15, 16–31, 32–47, 48–63, 64–79. 80–95, 96–111, 112–127.
Examples:
If, for example, you define a model trunk as XUT, with a model number of
12, all models in the group 1–15 will automatically be XUT models. If you
define another model trunk as an XEM, with a model number of 33, all
models in the group 32–47 will automatically be XEM models.
Note: When you create trunk models you are not prompted for the
trunk route or member number. This information is defined by using the
administration telephone to program the XUT or XEM circuit card.
For more information about LD 14 and its associated prompts and
commands, refer to the system software NTPs that are shipped with the
system.
Modifying model trunks
If you want to modify a trunk, load LD 14 and enter the following commands
on the TTY:
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.