Nortel Networks 1000M User Manual
Page 261
Startup procedures
261
Procedure 49
Startup procedure for a previously installed system
Step
Action
1
Test the power outlet. Make sure that the correct voltage of power is
present before you plug the power cord into the outlet. The source
must match the label on the back of the chassis.
2
Connect the power cord from the power connector on the back of the
chassis to an AC power source. See
on the back of the chassis" (page 260)
. Secure the power cable
with a cable tie.
3
Turn the power switch to ON.
4
Observe the TTY or terminal screen.
Messages appear on the TTY or the terminal screen. When the
message
INIXXX
appears, the system is in operation.
5
If required, set the system time and date using LD 2.
6
Perform an EDD using LD 43.
—End—
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.