Nortel Networks 1000M User Manual
Page 424
424
Changing preprogrammed data
CUST
0
SPDN
XXXX
where "XXXX" = value of Call Park extension
Repeat for each Call Park extension you wish to remove.
Conflicts with SDI ports
Five SDI/ESDI ports are preprogrammed on the Small System. Ports 8 and
9 are associated with the Meridian Mail card option, and ports 0, 1, and 2
are associated with the NTDK20 Small System Controller (SSC) card. You
cannot remove port 0; however, you can remove any of the remaining ports
using LD 17 as follows.
LD 17
REQ
CHG
TYPE
CFN
ADAN
OUT TTY X
where "X" = the TTY that you are removing
Conflicts with the SPRE code
If the preprogrammed SPRE code interferes with the programming required
for the Small System, use LD 15 to remove it. (For some countries, the
default SPRE access code is listed in
Table 75 "Default numbering plan:
.) For customer 0 enter the following in response
to the SPRE prompt:
LD 15
SPRE
X y where "y" = the value of the SPRE code
Note: To define a new SPRE code, type a space and enter the new
number.
Conflicts with the attendant extension number
You cannot remove the attendant extension number entirely from the Small
System data; you can only replace it with another number.
LD 15
REQ
CHG
where CHG = Change
TYPE
CDB
where CDB = Customer Data Block
CUST
x
where "x" = Customer number
ATDN
xxxx
where "xxxx" = the new extension number
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.