6 configuring a servo – Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set User Manual
Page 75

Configuring Axes
Chapter 3
3-11
For each axis, the type of servo needs to be entered. To do this:
1.
Configure the axis type as described on page 3-6.
2.
Configure the servo by setting the:
Servo Hardware Type
Servo Loop Type
The full servo parameter selections will only become available when
both of these parameters are defined as a selection other than “None.”
a.
To set the servo hardware type, select “Configure Servo” under
the F2--Axis menu. You are prompted to select a servo type.
Choose between:
Select this Servo Type:
If you have this Servo Hardware:
Catalog #:
None
none
none
9/230 Digital (1394)
The 9/230 Digital CNC designed to be
connected to an Allen Bradley 1394
Digital Servo Amplifier.
8520-CSP
9/230 Digital (8520)
The 9/230 Digital CNC designed to be
connected to one of the Allen Bradley
8520 Digital Servo Amplifier.
8520-DSP
3 Axis Digital (8520)
A 9/260 or 9/290 CNC with one or more
three axis digital servo card(s).
8520-ENC3
4 Axis Digital (1394)
A 9/260 or 9/290 CNC with one or more
four axis servo card(s) designed to be
connected to an Allen Bradley 1394
Digital Servo Amplifier.
8520-SM4
1
4 Axis Digital (8520)
A 9/260 or 9/290 CNC with one or more
four axis servo card(s) designed to be
connected to an Allen Bradley 8520
Digital Servo Amplifier.
8520-ENC4
9/230 Analog
The 9/230 Analog CNC designed to be
connected to an Analog version of the
Allen Bradley 1394 drive or other Allen
Bradley Analog drives.
8520-SP or
8520-SPR
3 Axis Analog
A 9/260 or 9/290 CNC with one or more
three axis servo card(s) designed to be
connected to an analog version of the
Allen Bradley 1394 drive or other Allen
Bradley Analog drive.
8520-ASM3
4 Axis Analog
A 9/260 or 9/290 CNC with one or more
four axis servo card(s) designed to be
connected to an analog version of the
Allen Bradley 1394 drive or other Allen
Bradley Analog drive.
8520-SM4
1
9/440 Digital (1394)
The 9/440 CNC.
8520-xS5
1
The 8520-SM4 servo card can be configured to have both analog and 1394 Digital servos connected to
the same servo card for different axes.
3.6
Configuring a Servo