Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 486)

Tool Offset Parameters
Chapter 22
22-14
This section describes the parameters that are used to configure a tool
magazine or turret or other tool changing device. When a T-word is
programmed that requires a tool change, these parameters are used to set
the number of different tool positions and the direction of rotation of the
tool turret and magazine. Figure 22.2 shows a typical mill tool magazine.
Important: These parameters are used only in conjunction with the
random tool software option.
Figure 22.2
Typical Mill Tool Magazine
06 07 08 09
05 10
04 03 02 01
Use these parameters to configure the tool magazine/turret:
Parameter: Page:
Number of tool pockets 22-15
Tool table motion 22-16
This option is not available on grinder applications.
22.12
Tool Magazine/Turret
Parameters