Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 717)

Patch AMP
Chapter 41
41-15
Parameter Patch AMP Value Default Value Parameter Name
940 Minimum Spindle 3
Speed -- Gear 1
0.0 rpm 0.0 to 500.0 rpm
941 Minimum Spindle 3
Speed -- Gear 2
0.0 rpm 0.0 to 500.0 rpm
942 Minimum Spindle 3
Speed -- Gear 3
0.0 rpm 0.0 to 500.0 rpm
943 Minimum Spindle 3
Speed -- Gear 4
0.0 rpm 0.0 to 500.0 rpm
944 Minimum Spindle 3
Speed -- Gear 5
0.0 rpm 0.0 to 500.0 rpm
945 Minimum Spindle 3
Speed -- Gear 6
0.0 rpm 0.0 to 500.0 rpm
946 Minimum Spindle 3
Speed -- Gear 7
0.0 rpm 0.0 to 500.0 rpm
947 Minimum Spindle 3
Speed -- Gear 8
0.0 rpm 0.0 to 500.0 rpm
950 Maximum Spindle 3
Speed -- Gear 1
500.0 rpm 0.0 to 500.0 rpm
951 Maximum Spindle 3
Speed -- Gear 2
500.0 rpm 0.0 to 500.0 rpm
952 Maximum Spindle 3
Speed -- Gear 3
500.0 rpm 0.0 to 500.0 rpm
953 Maximum Spindle 3
Speed -- Gear 4
500.0 rpm 0.0 to 500.0 rpm
954 Maximum Spindle 3
Speed -- Gear 5
500.0 rpm 0.0 to 500.0 rpm
955 Maximum Spindle 3
Speed -- Gear 6
500.0 rpm 0.0 to 500.0 rpm
956 Maximum Spindle 3
Speed -- Gear 7
500.0 rpm 0.0 to 500.0 rpm
957 Maximum Spindle 3
Speed -- Gear 8
500.0 rpm 0.0 to 500.0 rpm
1002
2002
3002
Dir. to Move Off Limit Switch negative direction
off switch
--1 -- negative direction off switch
1 -- positive direction off switch
1012
2012
3012
Max % rated torque (--) 200 % 0 to 200%
1013
2013
3013
Teeth on motor gear for vel FB 1 1 to 32,767 teeth
1017
2017
3017
Load inertia ratio 1 : 0 0 -- 1:0
1 -- 1:1
2 -- 1:2
3 -- 1:3