Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 284)

Feedrate Parameters
Chapter 9
9-2
Standard motion feedrate parameters include:
Parameter: Page:
Rapid Feedrate For Positioning 9-2
Maximum Cutting Feedrate 9-3
Function
Use this parameter to determine the feedrate that is used by the control for
rapid positioning. This mainly includes the feedrate of axis motions when
in the G00 mode; however, this feedrate is used for other operations as
specified in your programming and operation manual.
Axis Parameter
Number
Axis Parameter
Number
(1) [1203] (7) [7203]
(2) [2203] (8) [8203]
(3) [3203] (9) [9203]
(4) [4203] (10) [10203]
(5) [5203] (11) [11203]
(6) [6203] (12) [12203]
Range
0.00000 to 243840.00000 mmpm
or
0.00000 to 9600.00000 ipm
Notes
This feedrate may be modified by the operator with the rapid feedrate
override switch.
A value for this feedrate is set independently for each axis. Motions that
use more than one axis for rapid positioning (including a virtual axis which
requires two axes to position) use a feedrate that will not exceed the rapid
feedrate for any of the moving axes. Refer to your operation and
programming manual for additional information.
9.1
Standard Motion Feedrate
Parameters
9.1.1
Rapid Feedrate for
Positioning