Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 495)

Tool Offset Parameters
Chapter 22
22-23
Function
Use this parameter to specify the maximum value that a Geometry Offset
may contain. This value represents the absolute maximum value per table
for all tool offsets in that table.
If the operator enters: then:
a positive number greater than the maximum value the control generates the error message:
a negative number less than the negative of the
maximum value
“OFFSET EXCEEDS MAX VALUE”
Refer to your programming and operation manual for more information.
Axis Parameter Number
Mill Grinder Lathe
All 247 (single process)
[20247] (process 1)
[21247] (process 2
— —
(1) [1411] [1413]
(2) [2411] [2413]
(3) [3411] [3413]
(4) [4411] [4413]
(5) [5411] [5413]
(6) [6411] [6413]
(7) [7411] [7413]
(8) [8411] [8413]
(9) [9411] [9413]
(10) [10411] [10413]
(11) [11411] [11413]
(12) [12411] [12413]
Range
0.000000 to 390.000000 inches/9906.0000 mm
0.000000 to 10000.000000 degrees
Notes
For mill applications, this parameter is global; the value set here applies to all
axes. For dual processing mill controls, this is a per process parameter. The
value set in the parameters applies to all of the axes assigned to that process.
For grinder and lathe applications, set this parameter independently for
each axis.
22.22
Maximum +/- Geometry
Offset