Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set User Manual
Page 566
Cylindrical/Virtual C Parameters
Chapter 30
30-2
The mill cylindrical interpolation parameters are covered on these pages:
Parameter:
Page:
Cylindrical Feed Axis Name
30-2
Cylindrical Park Axis Name
30-3
Cylindrical Linear Axis Name
30-4
Cylindrical Rotary Axis Name
30-5
Rotary Center Feed Coordinate
30-6
Rotary Center Park Coordinate
30-7
Feed Axis Park Location
30-13
Refer to your programming and operation manual for details on the
cylindrical interpolation feature.
Function
This parameter specifies the name of the machine axis that will be the feed
axis during cylindrical interpolation. The mill tool’s position along the
feed axis determines the depth of the contour cuts during cylindrical
interpolation.
Important: The machine axis named as the feed axis must be an axis in
the current machine configuration.
Parameter
Parameter Number
Single Process
Process 1
Process 2
Cylindrical Feed Axis Name
[233]
[20233]
[21233]
Range
Selection
Result
Selection
Result
(a)
A
(f)
W
(b)
B
(g)
X
(c)
C
(h)
Y
(d)
U
(i)
Z
(e)
V
(j)
none
Notes
This parameter is used for mill controls only. For dual--processing controls,
this is a per process parameter. The value set with this parameter applies to
all of the axes assigned to that process.
This feature is not available on the 9/230 control.
30.1
Mill Cylindrical Interpolation
Parameters
30.2
Cylindrical Feed Axis Name