Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 702)

Tuning AMP at the Machine
Chapter 40
40-24
Important: Only axis calibration parameters can be backed up from a
storage device.
If the axis calibration parameters are being copied from a backup of the
axis calibration parameters stored on a storage device:
1. Press the {FROM PORT A} or {FROM PORT B} softkey, depending on
which port the peripheral device is connected to.
This screen is displayed on the operator panel CRT:
ACTIVE COPY PARAMETERS
FROM: PORT A (or PORT B)
TO: AXIS CALIBRATION
DEVICE: ALLEN-BRADLEY 1770-SB
BAUD RATE: 9600
PARITY: NONE
STOP BITS: 1
DATA LENGTH: 8
YES NO
If you want: Press this softkey:
the control to backup the axis calibration
parameters from the peripheral device
{YES}
the backup procedure to abort {NO}
END OF CHAPTER