Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 615)

Angled Wheel Parameters
Chapter 35
35-3
Function
Use this parameter to select the physical axis of the grinding wheel. This
axis is perpendicular to the wheel spindle centerline.
Virtual Axis
(typically X)
Part
Wheel Axis
(typically W)
Wheel Axis
Angle +q
Axial Axis
(typically Z)
Axis
Parameter
Number
All [610]
Important: The wheel axis on an angled-wheel grinder can not be a dual
axis (positioned with a different axis using the same programmed axis
command).
Range
Selection Result Selection Result
(a) A (f) W
(b) B (g) X
(c) C (h) Y
(d) U (i) Z
(e) V (i) none
Nonangled-wheel grinders should have this parameter set as “none” (i).
Notes
This is a global parameter. The value set here applies to all axes.
35.2
Wheel Axis Name