Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 482)

Tool Offset Parameters
Chapter 22
22-10
Use the AMP parameter Cancel Tool Offsets on M02/M30 (page 37-12) to
determine if tool offsets are canceled at the end of a part program.
Range
Application type: Selection Results
Mill/Lathe (a) Do Not Cancel
(b) Cancel Wear Only
(c) Cancel Geom & Wear
Grinder (a) Do Not Cancel
(b) Cancel Geometry Offset
Notes
This is a global parameter; the value set here applies to all axes.
For Dual Processing controls, this is a per process parameter. The value set
in the parameters applies to all of the axes assigned to that process.
These subsections describe the parameters that are available for execution
of the G37 tool gauging features. The feedrate for execution of the G37
tool gauging features are discussed in chapter 10.
The G37s tool gauging feature modifies the values in the tool offset tables.
There are five G37s used to activate four gauging operations. They are:
G37, G37.1 Skip 1
G37.2 Skip 2
G37.3 Skip 3
G37.4 Skip 4
Note that the G37 and G37.1 codes are functionally the same. Refer to
your mill or lathe programming and operation manuals for more
information.
The parameters in this section for G37 cycles are:
Parameter: Page:
Position tolerance for Skip 1 -- 4 22-11
Add to Tool Offset for Skip 1 -- 4 22-12
Target offset for skip 01 -- 04 22-13
22.8
G37 Tool Gauging Cycle
Parameters