Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 79)

Configuring Axes
Chapter 3
3-15
If you are using a Dual-Processing Control, you can select between two
process applications. To change processes, press
[F5] .
The workstation displays this screen:
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Lathe AXIS: X - linear File : TEST
- Axis Parameters
-
Axis One’s Name : X
Axis Two’s Name : Y
Axis Three’s Name : Z
Axis Four’s Name : U
Axis Five’s Name : V
Axis Six’s Name : W
Axis Seven’s Name : C
Axis Eight’s Name : A
Axis Nine’s Name : B
Axis Ten’s Name : S
Axis Eleven’s Name : S
Axis Twelve’s Name : S
Axis Thirteen’s Name : S
Page 1 of 4
P1:
F5-Process
Select Process (P)
Copy Process (C)
Name Process (N)
Configure Process (G)
Set Process Priority (S)
Use the Select Process option to specify the process that the AMP parameter
screens will display
. To use the Select Process option, Press [P] .
The workstation displays this screen:
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Lathe AXIS: X - linear File : TEST
-- Axis Parameters --
Axis One’s Name : X
Axis Two’s Name : Y
Axis Three’s Name : Z
Axis Four’s Name : U
Axis Five’s Name : V
Axis Six’s Name : W
Axis Seven’s Name : C
Axis Eight’s Name : A
Axis Nine’s Name : B
Axis Ten’s Name : S
Axis Eleven’s Name : S
Axis Twelve’s Name : S
Axis Thriteen’s Name : S
Page 1 of 4
P1:
Select Process:
Process [1]:
Process [2]:
- Active - High (1)
- Inactive - High (2)
To select a process, press either
[1]
or
[2]
.
3.9.1
Changing Processes
3.9.2
Select Process