Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 281)

Jog Parameters
Chapter 8
8-23
Function
The value specified for this parameter is equal to the speed at which a
continuous jog move takes place when the traverse jog speed is selected
(typically this is selected by holding down the button when
jogging). This traverse feedrate may be modified by the operator using the
switch.
Axis Parameter
Number
Axis Parameter
Number
(1) [1003] (7) [7003]
(2) [2003] (8) [8003]
(3) [3003] (9) [9003]
(4) [4003] (10) [10003]
(5) [5003] (11) [11003]
(6) [6003] (12) [12003]
Range
0.00600 mmpm to 10160.00004 mmpm
or
0.00024 ipm to 400.00000 ipm.
Notes
This parameter must be set independently for each axis.
END OF CHAPTER
8.6
Traverse Jog Speed