Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 93

AlliedView™-EMS 4.0.3 Device Management Guide
Page 93 of 468
Port Lock
Basic Info
Displays basic information about port lock.
Interfaces Range
Displays information about port lock interfaces range.
MAC Control
MAC Control Sublayer
Displays information about the MAC Control sublayer on a single ethernet-
like interface.
Note
- The current firmware version returns a 'noSuchName' value for the
Unknown Opcodes Received and Unknown Opcodes Received (HC)
parameters.
MAC Control PAUSE
Displays information about the MAC Control PAUSE function on a single ethernet-
like interface.
Note
- The current firmware version returns a "noSuchName" value for the
Received Frames (HC) and Transmit Frames (HC) parameters.
Note
- Valid MIB Set values for the PAUSE Config parameter are "disabled" and
"enabled xmit and rcv". Attempting to set this parameter to any other value will
result in the error message: "The error occurred with 'Set' operation. Error: bad
value."
Port Trunking
Basic Info
Displays basic information about port trunking.
Note
- The current firmware version does not allow any of the parameters
under this table to be configured.
Balancing Criteria
Displays information about Aggregate Index.
Note
- The current firmware version does not allow the Balance Layer, Used
Addresses and Broadcast Type parameters to be configured.
Aggregator Info
Displays information about every Aggregator that is associated with this
system.
Aggregator Port List
Displays Link Aggregation Control information for every Aggregation Port
associated with this device.