Stacking menu – Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 336

AlliedView™-EMS 4.0.3 Device Management Guide
Page 336 of 468
Note
- The following parameters are not applicable to the AT-x600 series and should
be ignored:
•
Capability Bits
•
Advertised Bits
•
Received Bits
•
Remote Fault Advertised
•
Remote Fault Received
Aggregator Port List
Displays Link Aggregation Control information for every Aggregation Port
associated with this device.
Note
- The current firmware version returns a 'noSuchName' value for the Partner
Administrative System ID and Partner Operational System ID parameters.
Note
- The current firmware version does not allow the Actor Administrative Status
and Partner Administrative Status parameter to be configured. Attempting to
configure this parameter to any valid value will result in the error "The error
occurred with 'Set' operation. Error: gen error".
Note
- The current firmware version does not allow the following parameters to be
set to '0'.
•
Partner Administrative System Priority
•
Partner Administrative Port
•
Partner Administrative Port Priority
Enable
Enables the port.
Disable
Disables the port.
Stacking Menu
From the Stacking menu, you can view and edit the Stacking MIB.
Stack Status
Displays the stack status information of the device.