Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 396

AlliedView™-EMS 4.0.3 Device Management Guide
Page 396 of 468
Displays the Location information as advertised by the remote system.
POE Info
Displays information about PoE type of the remote devices connected
to the ports.
POE/PSE Info
Displays information about Extended PoE PSE information for the remote
devices connected to the ports.
POE/PD Info
Displays information about XPoEPD information as advertised by the remote
system.
802.3 Config
Port Config
Displays the LLDP configuration information that controls the transmission
of IEEE 802.3.
Note
- Device Manager does not handle objects of type BITS correctly. As a
result, the 802.3 TLVs Tx Enable parameter will not be configurable and will
display an 8-bit binary string instead of the actual TLV types allowed.
However, the TLV types allowed can still be determined by looking at the
bits that are on from left to right:
•
Bit 0 - MAC Physical Config Status
•
Bit 1 - Power Via MDI
•
Bit 2 - Link Aggregation
•
Bit 3 - Max Frame Size
Note
- When multiple units of the AT-x900-24X series are stacked together,
the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only
installed XEM module in the device.
Local System
Ethernet Port Info
Displays information about a particular port component.
Note
- When multiple units of the AT-x900-24X series are stacked together,
the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only
installed XEM module in the device.
Link Aggregation Info
Displays link aggregation information about a particular port component.
Note
- When multiple units of the AT-x900-24X series are stacked together,
the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only
installed XEM module in the device.