Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 376

AlliedView™-EMS 4.0.3 Device Management Guide
Page 376 of 468
Bandwidth Limits
Displays bandwidth limits of the switch ports.
Note
- The current firmware version does not allow the Ingress Limit
parameter to be configured.
Error Statistics
Displays error statistics.
Note
- The following parameters are not applicable to the AT-x900-24X series and
should be ignored:
•
Ethernet Chip Set
•
Symbol Errors
•
Duplex Status
•
Rate Control Ability
•
Rate Control Status
Spanning Tree Info
Displays the port's spanning tree parameters.
Note
- The Path Cost Contribution parameter is not applicable to the AT-x900-24X
series and should be ignored.
Note
- Valid MIB Set values for the Port Path Cost parameter is in the range [1-
65535] inclusive.
MAU Info
Displays interface-related MAU information for the port.
Note
- The MAU Type List Bits and HC False Carriers parameters are not applicable
to the AT-x900-24X series and should be ignored.
Note
- The MAU Status and Default MAU Type parameters are implemented as
'read-only'.
MAU Negotiation Info
Displays the MAU's auto-negotiation settings and its status.
Note
- The following parameters are not applicable to the AT-x900-24X series and
should be ignored:
•
Capability Bits
•
Advertised Bits
•
Received Bits
•
Remote Fault Advertised
•
Remote Fault Received