Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 326)

AlliedView™-EMS 4.0.3 Device Management Guide Page 326 of 468
Bridge Port Info
Displays bridge port information.
Note - The current firmware version returns the value 'NULL' for the Circuit
parameter.
802.1p
Device Capabilities
Displays the device capabilities information.
Traffic Class
Displays the bridge traffic class and received traffic class info.
Note - The Traffic Class Priority parameter is not applicable to the AT-x600 series
and should be ignored.
Note - The Received Traffic Class parameter is implemented as 'read-only'.
POE Menu
From the POE menu, you can view and edit the POE configuration, port configuration and
notification control components.
Note - The POE Menu is only applicable to the AT-x600-24TS/POE and AT-x600-
24TS/POE+ device models.
PSE Config
Displays attributes for the main power source in PSE device.
Port Config
Displays the POE attributes of individual ports.
Note - The current firmware version does not allow the Power Pairs parameter to
be set to 'signal' as its value.
Note - The current firmware version does not allow the Port Type parameter to be
set to 'NULL'.
Note - The Power Pairs, Power Priority, and Port Type parameters cannot be set to
any valid values when Function Enabled parameter is set to 'false'.
Notification Control
Displays the notifications on a PSE device.