Port menu – Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 172

AlliedView™-EMS 4.0.3 Device Management Guide
Page 172 of 468
Alarm Table
Displays the RMON Alarm table.
Event Table
Displays the RMON Event table.
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Standard
Displays port statistics such as the number of packets received and
transmitted on the port, bytes received and transmitted on the port and port
status. This table also displays high-capacity port statistics including received
and transmitted unicast/multicast/broadcast packets on the port, link
up/down trap and port speed.
Note
- Valid MIB Set values for the Administration Status parameter are 'up'
and 'down'. Attempting to set this parameter to any other value will result in
the error message: "The error occurred with 'Set' operation. Error: bad
value."
Note
- The current firmware version does not allow the Promiscuous Mode
and Port Alias parameters to be configured.
Note
- The current firmware version does not allow Device Manager to
display the Port Description parameter configured via CLI.
Note
- Using firmware ATS62 v1.4.0, the Device Manager may intermittently
return a "retry over occurred" value for the Extended Interface Info table.
Additional Info
Displays port statistics such as the number of frames received and
transmitted on the port, bytes received and transmitted on the port and port
status.
Error Statistics
Displays error statistics.