beautypg.com

Agent menu – Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 276

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 276 of 468

Note

- Status information for ports 21 to 24 on the AT-9724TS and ports 45 to 48 on the

AT-9748TS/XP will always be reflected on both the RJ-45 port images and the SFP port

images regardless of whether it is the RJ-45 or the SFP ports that are actually in operation.

However, if Device Manager detects that the established link speed is less than 1Gbps, only
the RJ-45 port images will turn green.

Agent Menu

From the Agent menu, you can view and edit the system information for the switch, or log

into the CLI using Telnet.

System Info

Displays basic system information, including system name, location, contact and

description.


Device Info

Equipment Capacity

Displays the equipment capacity supported in the system.


Power Supply Info

Displays information about the power supply and redundant power supply .


Fan Info

Displays fan status.


Unit Info

Displays information about the system's stacking mode, units supported in the

system, total number of ports and number of ports in use.


Unit Management Info

Displays management information for each unit in the system.

Module Info

Displays module information for each unit in the system.

Management Info

General Info

Displays common management information.


General Config

Displays basic control of the system.

Note

- The current firmware version does not allow the RS-232C Mode parameter

to be configured.

Note

- It may take a while for the device to set the STP Status parameter to ‘enable’.

As a result, a timeout error may occur. However, the value is still set successfully.