beautypg.com

Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 281

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 281 of 468

Interface Config

Displays the list of subnets which require separate configuration in Routing

Information Protocol.

Note

- The current firmware version does not allow the Domain and Default

Metric parameters to be configured.

Note

- Valid MIB Set values for the Row Status parameter are 'active' and 'not

in service'. Attempting to set this parameter to any other value will result in

the error message: "The error occurred with 'Set' operation. Error: bad

value".

Note

- The current firmware version does not allow the following parameters

to be configured:

Domain

Authentication Key

Default Metric

Source IP Address

Active Peer Info

Displays information about active peer relationships.

OSPF

Basic Info

Displays basic information about Open Shortest Path First routing protocol.

Note

- The current firmware version does not allow the following parameters to be

configured:

AS Border Router Status

Type of Service Support Status

Ext Link State DB Limit

Multicast Extensions

Exit Overflow Interval

Demand Extensions

Area Info

Displays the configured parameters and cumulative statistics of the device's

attached areas.

Note

- The Authentication Type parameter is not applicable to the AT-9700

Series and should be ignored.


Stub Area Config

Displays the set of metrics that will be advertised by a default Area Border

Router into a stub area.