Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 226)

AlliedView™-EMS 4.0.3 Device Management Guide Page 226 of 468
Rapier G6F-SX/MT
Device Manager LEDs for Rapiers
LED State Description
PWR Green
Red
The switch is receiving power from the main power supply.
The main power supply has failed.
RPS Green
Red
Gray
The switch is receiving power from the redundant power supply.
RPS has failed.
RPS is not installed or RPS monitoring is disabled.
DUPLEX Green
Orange
The port is operating at full duplex.
The port is operating at half duplex.
Note - The current firmware version does not allow Device Manager to support the
Reset button.
Note - Please refer to Uplink Modules for the operations and behavior of the uplink
modules installed in these devices.
Note - Please refer to Network Service Modules for the operations and behavior of the
Network Service Modules installed in these devices.
Note - To turn RPS monitoring on or off on the switch, enter the command SET SYSTEM
RPSMONITOR={ON|OFF} from the command line interface. To see whether RPS
monitoring is on, use the command SHOW SYSTEM. To turn on RPS monitoring using
SNMP, set the fanAndPsRpsMonitoringStatus variable to on.