Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 321

AlliedView™-EMS 4.0.3 Device Management Guide
Page 321 of 468
the error message "The error occurred with 'Set' operation. Error: time out
occurred".
Note
- Valid MIB Set values for the Name Address parameter is from 1 to
256 characters. However, the current firmware version allows the user to
enter values greater than the valid range.
Associations
Displays the NTP Association on the device.
NTP Info
Displays the peer index's next available value.
System Log
Log Entries
Displays information of the log entries on the device.
Note
- The current firmware version returns a 'noSuchName' value
intermittently for the Log Entries parameter when using SNMPv1.
Log Options
Displays the log options on the device.
Trigger
Trigger Info
Displays the trigger configuration information in the device.
Trigger Counters
Displays counters in activation of the triggers in the device.
Remote Ping
Ping Objects
Displays the maximum number of concurrent active ping requests.
Note
- The Target Address Type parameter is implemented as 'read-only'.
Ping Control
Defines the Ping Control Table for providing, via SNMP, the capability of
performing ping operations at a remote host.
Note
- Valid MIB Set values for the Data Size parameter should range from 0-
65507. However, the current firmware version does not allow this
parameter to be set to 0-7 as its value.
Note
- The current firmware version does not allow the Destination Port
Number parameter to be configured.