Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 43)

AlliedView™-EMS 4.0.3 Device Management Guide Page 43 of 468
Note - The current firmware version does not allow the Mapping Type
parameter to be configured. Attempting to configure this parameter from
'static' to 'dynamic' value will result in the error "The error occurred with
'Set' operation. Error. bad value.".
Note - The current firmware version does not allow the Mapping Type
parameter to be set to 'invalid' or 'other' as its values.
Address Table
Standard
Displays the list of IP interfaces on the switch.
Additional Info
Displays additional information about the address table.
Note - The Backup Address parameter is not applicable to the AT-8000GS
series and should be ignored.
Note - The current firmware version does not allow the IP Interface Owner
parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation.
Error. bad value.".
Note - Configuring the Port Number parameter will cause the device to be
inaccessible and may need the restarted.
Note - The current firmware version does not allow the Net Mask parameter
to be configured.
Static Route Table
Displays the IP static routing table.
Note - The current firmware version does not allow the Routing Type
parameter to be set to 'local' as its value.
IP Statistics
Displays statistics about IP routing, including the number of IP datagram
received.
Note - The current firmware version does not allow the Forwarding Status
parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation.
Error. bad value.".
ARP Table Config
Displays configuration information about ARP.