Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 115)

AlliedView™-EMS 4.0.3 Device Management Guide Page 115 of 468
Additional Info
Displays port statistics such as the number of frames received and
transmitted on the port, bytes received and transmitted on the port and port
status.
Error Statistics
Displays error statistics.
Detail Info
Displays detailed port information such as duplex mode.
Note - The Port State parameter always returns the value 'enabled' even if the
physical port is actually disabled.
Note - When an auto-negotiated link is established on a redundant port (RJ-45), its
Port Speed parameter, as well as its port image, may not always reflect the correct
negotiated speed if there is an established link on any of the other three SFP ports.
Note - The current firmware version returns a 'noSuchName' value for the Port
Flow Control and Port QoS Priority parameters. It also does not allow the
parameters to be configured.
Spanning Tree Info
Displays the port's spanning tree parameters.
Enable
Enables the port.
Disable
Disables the port.
Port Mirroring
Displays port mirroring parameters and allows configuration of port mirroring state,
source and destination.
IGMP Snooping
Displays the current state of IGMP Snooping and allows reconfiguration.
AT-9000/24