Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 355)

AlliedView™-EMS 4.0.3 Device Management Guide Page 355 of 468
Location Info
Displays the Location information as advertised by the remote system.
POE Info
Displays information about PoE type of the remote devices connected to the
ports.
POE/PSE Info
Displays information about Extended PoE PSE information for the remote
devices connected to the ports.
POE/PD Info
Displays information about XPoEPD information as advertised by the remote
system.
802.3 Config
Port Config
Displays the LLDP configuration information that controls the transmission
of IEEE 802.3.
Note - Device Manager does not handle objects of type BITS correctly. As a
result, the 802.3 TLVs Tx Enable parameter will not be configurable and will
display an 8-bit binary string instead of the actual TLV types allowed.
However, the TLV types allowed can still be determined by looking at the
bits that are on from left to right:
•
Bit 0 - MAC Physical Config Status
•
Bit 1 - Power Via MDI
•
Bit 2 - Link Aggregation
•
Bit 3 - Max Frame Size
Note - When multiple units of the AT-x900-12X series are stacked together,
the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only
installed XEM module in the device.
Local System
Ethernet Port Info
Displays information about a particular port component.
Note - When multiple units of the AT-x900-12X series are stacked
together, the 'Base Ports' submenu is displayed even if the AT-XEM-
STK is the only installed XEM module in the device.
Power Ethernet Port Info
Displays power ethernet information on particular port component.