Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 40)

AlliedView™-EMS 4.0.3 Device Management Guide Page 40 of 468
CLI Info
Displays information if the file is enabled or not.
Note - The current firmware does not allow the Password parameter to be
configured.
LCLI Info
Displays information about the device's Telnet sessions and SSH sessions if
enabled or not.
Note - Valid MIB Set values for the History Size and SSH History Size
parameters should range from 10-206 and 10-210 respectively. However, the
current firmware version allows the user to enter values up to 246.
Note - Valid MIB Set values for the Telnet History Size parameter is [10-206]
inclusive. However, the current firmware version allows the user to enter
values up to 246.
RS-232
Displays the configuration of the baud rate of the device.
Web Server
Web Info
Displays embedded Web protocol.
Note - Setting the HTTP Port and HTTPS Port parameters to '0' will
automatically set the parameters to their default port numbers which
are 80 and 443 respectively.
Web Services
Displays the services used for the embedded Web protocol.
Note - The current firmware version does not allow the Service Port, Service
Certificate and Service Max Idle Timeout parameters to be set to '0', '1000'
and '932160' values respectively.
Note - Valid MIB Set values for the Service Certificate ID parameter
is [0-1000] inclusive. However, the current firmware version allows the user
to enter '-1' and '1001' as its value.
Note - The current firmware version does not allow the Service Protocol
parameter to be configured.