beautypg.com

Agent menu – Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 118

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 118 of 468

Note

- The current firmware version does not allow Device Manager to detect the presence

or absence of an SFP module in any of the SFP slots. As a result, the SFP slots on the device

image will always show SFP images regardless of whether or not SFP modules are physically

present in the slots.

Note

- The current firmware version does not allow Device Manager to determine the

actual duplex mode of the ports. As a result, the Duplex LED image is always GRAY

regardless of an active connection.

Note

- When the Spanning Tree Status parameter is set to 'enable', the current firmware

version does not return a value of 'blocking' for the Port State parameter of blocking ports.

As a result, blocking ports will remain green and will not turn to yellow.

Note

- AT-9000/28 & AT-9000/28SP: Context menu for SFP/RJ-45 combo ports will always

be accessible on both the RJ-45 port images and the SFP port images regardless of whether

it is the RJ-45 or the SFP ports that are actually in operation.

Note

- AT-9000/28 & AT-9000/28SP: Status information for SFP/RJ-45 combo ports will

always be reflected on both the RJ-45 port images and the SFP port images regardless of

whether it is the RJ-45 or the SFP ports that are actually in operation. However, if Device

Manager detects that the established link speed is 10Mbps, only the RJ-45 port images will

turn green.

Agent Menu

From the Agent menu, you can view and edit the system information for the device, or log

into the CLI using Telnet.

System Info

Displays basic system information, including system name, location, contact and

description.

Note

- Valid MIB Set values for the System Contact parameter is up to 255

characters. However, values exceeding 127 characters will be truncated.


Network Info

Displays network-related information such as the addresses of the default gateway

and the agents.

Note

- The current firmware version does not allow the Configured Default

Gateway parameter to be configured.


Device Info

Displays general information about the switch.


Reset

Resets the switch.