beautypg.com

Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 334

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 334 of 468

Transmitted Broadcast Packets (HC)

Note

- The Promiscuous Mode parameter is implemented as 'read-only'.

Note

- The Counter Discontinuity Time parameter is not applicable to the

AT-x600 series and should be ignored.

Note

- Valid MIB Set values for the Port Alias parameter is up to 64

characters. Attempting to enter values greater than the valid range will be

accepted but values exceeding 64 characters will be truncated.

Error Statistics

Displays error statistics.

Note

- The Ethernet Chipset parameter is not applicable to the AT-x600 series and

should be ignored.


Received Address

Displays the address for which the system will accept packets/frames on the
particular interface.

Note

- The Received Address parameter is not applicable to the AT-x600 series

and should be ignored.

Note

- The Received Address Status and Received Address Type parameters are

implemented as 'read-only'.


Spanning Tree Info

Standard

Displays the port's spanning tree parameters.

Note

- Valid MIB Set values for the Port Path Cost parameter is in the range

[1-65535] inclusive.

Note

- The current firmware version does not allow the Port parameter

to be configured.

Note

- The current firmware version does not allow the Port Priority, Port,

Port Path Cost and Path Cost Contribution parameters to be configured.


Additional Info

Displays additional information on the port's spanning tree parameters.

Note

- The current firmware version does not allow the Protocol Migration

parameter to be set to 'true'.

Note

- The current firmware version does not allow the Point-to-Point

Config parameter to be set to 'auto'.