beautypg.com

Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 359

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 359 of 468

Note

- When multiple units of the AT-x900-12X series are stacked together,

the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only

installed XEM module in the device.

Error Statistics

Displays error statistics.

Note

- The Ethernet Chipset parameter is not applicable to the AT-x900-12X series

and should be ignored.

Note

- When multiple units of the AT-x900-12X series are stacked together, the

'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed XEM

module in the device.


Received Address

Displays the address for which the system will accept packets/frames on the

particular interface.

Note

- The Received Address parameter is not applicable to the AT-x900-12X series

and should be ignored.

Note

- The Received Address Status and Received Address Type parameters are

implemented as 'read-only'.

Note

- When multiple units of the AT-x900-12X series are stacked together, the

'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed XEM

module in the device.


Spanning Tree Info

Standard

Displays the port's spanning tree parameters.

Note

- Valid MIB Set values for the Port Path Cost parameter is in the range

[1-65535] inclusive.

Note

- The current firmware version does not allow the Port parameter to

be configured.

Note

- The current firmware version does not allow the Port Priority, Port,

Port Path Cost and Path Cost Contribution parameters to be configured.

Note

- When multiple units of the AT-x900-12X series are stacked together,

the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only

installed XEM module in the device.