Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 290)

AlliedView™-EMS 4.0.3 Device Management Guide Page 290 of 468
Note - The current firmware version accepts values in the range [0-255]
inclusive for the Query Maximum Response Time and Last Member Query
Interval parameters. However, if the value entered is not a multiple of 10, the
firmware will convert it to the largest multiple of 10 less than the entered
value. Values less than 10 but greater than 0 will be converted to 10.
Router Cache Info
Displays the list of IP multicast groups for which there are members on a
particular interface.
Note - The Router Cache Info sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter
with a value of ‘noSuchName’.
VRRP Menu
From the VRRP menu, you can view and edit VRRP-related information such as the current
VRRP version, VRRP status, VRRP statistics and IP addresses associated with VRRP.
Basic Info
Displays basic information such as the particular version of the Virtual Routing
Redundancy Protocol supported by the device and the whether the VRRP-enabled
router will generate SNMP traps.
Note - The current firmware version returns 'noSuchName' for the Trap Packet IP
Address and Trap Authentication Error Type parameters.
Operations
Displays the table containing statistics information about a given virtual router.
Note - The current firmware version does not allow the Primary IP Address and
Authentication Key parameters to be configured.
Note - The current firmware version does not allow the Priority parameter to be
configured when the Virtual IP Address (VRRP -> Associated IP Addresses) and the
Master IP Address (VRRP -> Operations) values are the same.
Associated IP Addresses
Displays the table of addresses associated with this virtual router.
Statistics
Diplays the total number of VRRP packets received with an invalid VRRP checksum
value, with an unknown or unsupported version number and with an invalid VRID
for this virtual router.