Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 361)

AlliedView™-EMS 4.0.3 Device Management Guide Page 361 of 468
Note - The current firmware version returns the value 'NULL' for the MAU Type
and Default MAU Type parameters.
Note - When multiple units of the AT-x900-12X series are stacked together, the
'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed XEM
module in the device.
MAU Negotiation Info
Displays the MAU's auto-negotiation settings and its status.
Note - The Administration Status and Restart parameters are implemented as 'read-
only'.
Note - The Advertised Negotiation Capability parameter is not applicable to the AT-
x900-12X series and should be ignored.
Note - The Negotiation Capability, Advertised Negotiation Capability and Received
Negotiation Capability parameters are not applicable to the AT-x900-12X series and
should be ignored.
Note - The following parameters are not applicable to the AT-x900-12X series and
should be ignored:
•
Capability Bits
•
Advertised Bits
•
Received Bits
•
Remote Fault Advertised
•
Remote Fault Received
Note - When multiple units of the AT-x900-12X series are stacked together, the
'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed XEM
module in the device.
Aggregator Port List
Displays Link Aggregation Control information for every Aggregation Port
associated with this device.
Note - The current firmware version returns a 'noSuchName' value for the Partner
Administrative System ID and Partner Operational System ID parameters.
Note - The current firmware version does not allow the Actor Administrative Status
and Partner Administrative Status parameter to be configured. Attempting to
configure this parameter to any valid value will result in the error "The error
occurred with 'Set' operation. Error: gen error".