Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 92)

AlliedView™-EMS 4.0.3 Device Management Guide Page 92 of 468
Note - The current firmware version does not allow the following parameters to be
configured:
•
Tagged Mode
•
Default Priority
•
Row Status
•
Port Speed
•
Reactivate
•
Combo Ethernet Config
Note - The current firmware version does not allow the Autonegotiation Capabilities
Config parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation. Error:
bad value."
Note - The combo ports will not display the Port Context Menu on right-mouse
click if logged-on in SNMPv3 mode using a user account with no read-write access
to the Transceiver Type parameter.
POE Port Status
Displays additional information for Power Over Ethernet ports.
Note - The current firmware version does not allow the Power Limit parameter to
be configured.
Spanning Tree Info
STP
Detail Info
Displays the port's spanning tree parameters.
Additional Info
Displays a list of information maintained by every port about the Spanning
Tree Protocol state for that port.
MSTP
MSTI
Displays a list of information maintained by every pair
about the Spanning Tree Protocol state for that pair.
CIST
Displays a list of information maintained by every port of the CIST.
Enable
Enables the port.
Disable
Disables the port.