Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 327)

AlliedView™-EMS 4.0.3 Device Management Guide Page 327 of 468
LLDP Menu
From the LLDP menu, you can view and edit LLDP configurations, statistics, local system
data and remote systems data components.
Note - When multiple units of the AT-x600 series are stacked together, port numbering is
continuous based on the Stack ID.
•
Stack ID 1 = 1 - 50
•
Stack ID 2 = 51 - 100
•
Stack ID 3 = 101 - 150
•
Stack ID 4 = 151 - 200
•
Stack ID 5 = 201 - 250
•
Stack ID 6 = 251 - 300
•
Stack ID 7 = 301 - 350
This numbering scheme assumes that a unit can have a maximum of 50 ports.
LLDP Configuration
General Config
Displays LLDP general function such as enabling LLDP, transmission delays
and others.
Port Config
Standard
Displays the LLDP configuration information of a particular port.
Note - Device Manager does not handle objects of type BITS correctly.
As a result, the TLVs Tx Enable parameter will not be configurable
and will display an 8-bit binary string instead of the actual TLV types
allowed. However, the TLV types allowed can still be determined by
looking at the bits that are on from left to right:
•
Bit 0 - Port Description
•
Bit 1 - System Name
•
Bit 2 - System Description
•
Bit 3 - System Capabilities
Additional Info
Displays the control selection of LLDP Port VLAN-ID TLVs
(Type-Length-Value) to be transmitted on individual ports.
Management Addresses
Displays control selection of LLDP management address TLV instances to be
transmitted.