Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 324

AlliedView™-EMS 4.0.3 Device Management Guide
Page 324 of 468
Note
- The following parameters are implemented as 'read-only':
•
Destination Port Number
•
Routing Type
•
Routing Protocol MIB
•
Next Hop AS Number
•
Destination Metric 1
•
Destination Metric 2
•
Destination Metric 3
•
Destination Metric 4
•
Destination Metric 5
•
Row Status
IP Statistics
Displays statistics about IP, such as the number of IP datagrams received.
Note
- Valid MIB Set values for the Default TTL parameter should range from
1-255. However, the current firmware version does not allow this parameter
to be set to '1' as its value. Attempting to set this parameter to '1' will result
in the error message "The error occurred with 'Set' operation: time out
occurred." Connection with the device will be lost and the only way to
re-establish connection will be to perform a manual reset.
Note
- Setting the Forwarding Status parameter to 'not forwarding' will not
return an error message but connection with the device will be lost.
The only way to re-establish connection will be to perform a manual reset.
UDP
Listener Info
Displays UDP listener information.
UDP Statistics
Displays UDP statistics.
TCP
Connection Info
Displays TCP connection-specific information.
Note
- The Connection Status parameter is implemented as 'read-only'.
TCP Statistics
Displays TCP statistics.
ICMP Statistics
Displays ICMP statistics.