Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 243)

AlliedView™-EMS 4.0.3 Device Management Guide Page 243 of 468
Port Menu
From the Port menu, you can view and edit MIB information about selected ports.
Utilization
Displays the port's utilization information.
Interface Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port, and port status. This table also
displays high-capacity port statistics including received and transmitted
unicast/multicast/broadcast packets on the port, link up/down trap and port speed.
Note - The current firmware version returns a 'noSuchName' value for the Port
Alias and Counter Discontinuity Time parameters.
Note - Although the current firmware allows the Administration Status parameter to
be set to 'testing', the value 'testing' is not a valid MIB Set value.
Note - The Promiscuous Mode parameter is implemented as 'read-only'.
Detail Info
Duplex Mode
Displays the duplex mode of the ports.
Bandwith Limits
Displays bandwidth limits of the switch ports.
Error Statistics
Displays error statistics.
Note - The following parameters are not applicable to AT-Rapier48w and should
be ignored:
•
Ethernet Chip Set
•
Symbol Errors
•
Duplex Status
Spanning Tree Info
Displays the port's spanning tree parameters.
MAU Info
Displays interface-related MAU information for the port.
Note - The MAU Type List Bits and HC False Carriers parameters are not applicable
to the AT-Rapier48w and should be ignored.