Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 413

AlliedView™-EMS 4.0.3 Device Management Guide
Page 413 of 468
Additional Info
Displays the information of the IP Address of the device.
Note
- Device Manager does not handle objects of type OCTET
STRING correctly. As a result, the Address parameter will display a
sequence of bytes in hexadecimal format instead of the actual IP
address of the device.
Note
- The current firmware version does not allow the Port Number
and Assignment Type parameters to be configured.
Note
- The current firmware version allows the user to enter up to
128 characters for the Label parameter but truncates entered values
to 127 characters.
Note
- Configuring Prefix Length parameter will result in the error
message "The error occurred with 'Set' operation. Error: time out
occurred." However, the new value is still set successfully.
Route Number
Displays the IP routing number on the switch.
Route Table
Displays the IP routing table on the switch.
Note
- The current firmware version returns the value 'NULL' for the
Routing Protocol MIB parameter.
Note
- The following parameters are implemented as 'read-only':
•
Destination Port Number
•
Routing Type
•
Routing Protocol MIB
•
Next Hop AS Number
•
Destination Metric 1
•
Destination Metric 2
•
Destination Metric 3
•
Destination Metric 4
•
Destination Metric 5
•
Row Status