Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 335

AlliedView™-EMS 4.0.3 Device Management Guide
Page 335 of 468
Note
- Valid MIB Set values for the Port Path Cost Config parameter
is [1-200000000] inclusive. However, the current firmware version allows
the user to set this parameter to '0' as its value and will automatically set the
entered value to valid values.
Note
- The current firmware version does not allow the Protocol Migration,
Edge Port, Point-to-Point Config and Port Path Cost Config parameters to be
configured.
MAC Control Pause
Displays information about the MAC Control Pause function on a single ethernet-
like interface.
Note
- The current firmware version returns a 'noSuchName' value for the Received
Frames (HC) and Transmit Frames (HC) parameters.
Note
- The PAUSE Config parameter is implemented as 'read-only'.
MAU Info
Displays interface-related MAU information for the port.
Note
- The MAU Status and Default MAU Type parameters are implemented as
'read-only'.
Note
- The MAU Type List parameter is not applicable to the AT-x600 series and
should be ignored.
Note
- The Mau Type List Bits and HC False Carriers parameters are not applicable
to the AT-x600 series and should be ignored.
Note
- The current firmware version returns the value 'NULL' for the MAU Type
and Default MAU Type parameters.
MAU Negotiation Info
Displays the MAU's auto-negotiation settings and its status.
Note
- The Administration Status and Restart parameters are implemented as 'read-only'.
Note
- The Advertised Negotiation Capability parameter is not applicable to the
AT-x600 series and should be ignored.
Note
- The Negotiation Capability, Advertised Negotiation Capability and Received
Negotiation Capability parameters are not applicable to the AT-x600 series and
should be ignored.