Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 46)

AlliedView™-EMS 4.0.3 Device Management Guide Page 46 of 468
Note - Configuring the Row Status parameter to invalid values will not
return an error message except for the 'create and go' value.
Enabled VLANs
Displays the IP DHCP snooping enabled VLAN entries.
Note - Configuring the Row Status parameter to invalid values will not
return an error message except for the 'create and go' value.
Trusted Ports
Displays DHCP snooping configured as trusted ports.
Note - Configuring the Row Status parameter to invalid values will not
return an error message except for the 'create and go' value.
DNS Resolver
Resolver Config
Displays information about the DNS client.
Note - The current firmware version does not allow the Reset parameter to
be configured to 'reset' as its value. Attempting to configure this parameter
to any valid value will result in the error "The error occurred with 'Set'
operation. Error. bad value.".
Basic Counters
Displays information about basic DNS counters.
Counters by OpCode
Displays information about the current count of resolver queries and
answers.
Counters by Response Code
Displays information about the current count of responses to resolver
queries.
Lame Delegation Overflows
Displays information about number of times the resolver attempted to add
an entry to the lame delegation table.
Cache Info
Displays information about a collection of objects providing access to and
control of a DNS resolver's cache.
Negative Cache Info
Displays information about a collection of objects providing access to and
control of a DNS resolver's negative response cache.