Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 76)

AlliedView™-EMS 4.0.3 Device Management Guide Page 76 of 468
Additional Info
Displays additional information about the address table.
Note - The current firmware version does not allow the Port
Number, Net Mask and IP Interface Owner parameters to be
configured.
Note - The Backup Address parameter is not applicable to the
AT-8000S series and should be ignored.
Static Route Table
Displays the IP static routing table.
Note - The current firmware version does not allow the Routing Type
parameter to be set to 'local'.
IP Statistics
Displays statistics about IP routing, including the number of IP datagram
received.
Note - The current firmware version does not allow the Forwarding Status
parameter to be configured.
ARP Table Config
Displays configuration information about ARP.
Note - The current firmware version does not allow Unresolve Timer to be
configured.
I/F Name-Address Translation
Displays information about the IP interface's name translated to an
IP interface address.
TFTP
Displays configuration information about the TFTP.
Note - The current firmware version does not allow Send Config File
parameter to be configured to send config/image/boot files to a TFTP server.
Note - The current firmware version does not allow Get Config File
parameter to be configured to receive image/config/boot files from a TFTP
server. Attempting to set this parameter to any valid value will cause the
device to be restored to its default configuration.
UDP
Listener Info
Displays UDP listener information.