Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 67)

AlliedView™-EMS 4.0.3 Device Management Guide Page 67 of 468
Device Manager LEDs for AT-8000S Series
LED State Description
PWR Green The switch is receiving power.
STACK ID Orange
Gray
Green
The stacked unit is either the Stacking Master or the Backup
Master.
The switch is a set to standalone mode.
The stacked unit is a slave switch.
DUPLEX Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
Note - When multiple units of the AT-8000S series are stacked together, port numbering is
continuous based on the Box ID.
•
Box ID 1 - 1 to 54
•
Box ID 2 - 55 to 108
•
Box ID 3 - 109 to 162
•
Box ID 4 - 163 to 216
•
Box ID 5 - 217 to 270
•
Box ID 6 - 271 to 324
This numbering scheme assumes that a unit can have a maximum of 54 ports.
Combo ports on the AT-8000S/24 and AT-8000S/24POE devices are assigned port
numbers 49 and 50.
Note - The current firmware version does not allow Device Manager to detect the presence
of an SFP module in any of the SFP slots unless there is an active connection on the SFP
ports. As a result, SFP images will appear on the device panel only if there is an established
connection on the physical SFP ports.
Note - The current firmware version does not allow Device Manager to handle redundant
ports. As a result, the Duplex LED of the copper ports will remain green even if there is an
established connection on the equivalent SFP ports.