Security menu – Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 160

AlliedView™-EMS 4.0.3 Device Management Guide
Page 160 of 468
Note
- Valid MIB Set values for the Number of Packets parameter should
range from 0-4294967595. However, the current firmware version allows
the user to enter negative values as well. Furthermore, attempting to set the
parameter to 0 will result in the error message: "The error occurred with
'Set' operation. Error: bad value."
Note
- The current firmware version accepts values in the range
[0-4294967595] inclusive for the Number of Packets and Time Interval
parameters.
Note
- Valid MIB Set values for the Timeout parameter should range from
1 to 65535. However, the current firmware version allows the user to enter
values in the range [-65535 to -1, 1 to 65535] inclusive. Attempting to enter
values greater than 65535 will cause the new value to be converted to its
equivalent wrap-around value; i.e., 65536 will become 0, 65537 will become 1,
and so on.
Note
- The current firmware version does not allow the Address parameter
to be configured.
Ping Statistics
Displays statistics of the Ping polling.
Security Menu
From the Security menu, you can view and edit port access entity information such as the
PAE port information and the Supplicant PAE information.
Port-based Authentication
Authentication Status
Displays the status of the port-based authentication.
PAE Port Info
Standard
Displays standard PAE port information.
Note
- The current firmware version returns a 'noSuchName' value for the
Port Number parameter.
Note
- Device Manager does not handle objects of type BITS correctly. As a
result, the Capabilities parameter will display an 8-bit binary string instead of
the actual PAE functionality supported. However, the PAE functionality
supported can still be determined by looking at the bits that are on from
right to left:
•
Bit 0 - Authenticator
•
Bit 1 - Supplicant