beautypg.com

Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 439

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 439 of 468

Note

- The Module Name parameter always displays 'yyyyyyyy' as its default value when not

yet configured.

Note

- AT-CV5M01: The current firmware version does not allow the Port Mode

parameter of FX type of ports to be configured. Attempting to configure this parameter

other than its current Port Mode value will result in the error message: "noSuchName."


Port Info

Note

- The value of the Port Mode parameter of a port with an established link

automatically changes to 'auto' when the settings of the port to which it is

connected are modified.

Note

- The value of the Port Speed parameter of a port with an established link

automatically changes to '10Mbps' when the value of its Port Mode parameter

is changed from 'auto' to 'manual'.

Note

- The current firmware version does not allow the Port Ingress Rate Limit and

Port Egress Rate Limit parameters to be configured.

Note

- AT-CV5M01: The current firmware version does not allow Port Speed and

Port Duplex Status parameters to be set to '1Gbps' and 'unknown' values

respectively.

AT-CM70S

4 x TI/E1 + 10/100TX over SFP-based fiber.