beautypg.com

Status menu – Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 447

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 447 of 468

System Config

Displays the device's system variables.

General Config

Displays the device's system configuration.

Note

- Valid MIB Set values for the System Name, System Contact and

System Location parameters are in the range [0-25] inclusive. However, the
current firmware version accepts inputs of up to 40 characters.

System Date and Time

Displays the system's Date, Time and Network Time Protocol configuration.

Note

- Configuring the NTP Mode parameter to "Enable" will result in the

error message: "The error occurred with 'Set' operation. Error: time out

occurred." but the NTP Mode will still be successfully set.

Note

- Configuring the NTP Server parameter will result in the error

message: "The error occurred with 'Set' operation. Error: time out

occurred." but the NTP Server address will still be successfully set.

System Log

Displays the system's log information.

Reset

Resets the chassis and/or modules.


Telnet

Starts a Telnet connection to the chassis.

Status Menu

From the Status Menu, you can view information about AT-MCF2000 Modules installed on

the chassis.

Port Info

Displays the port cofigurable parameters. Options to view all/module 1/module 2
information are displayed including the configurable parameters for the management

port.

Management Port Info

Displays the Management Module's port information.

Note

- Configuring the following parameters to any valid value will result in

the error message: "The error occurred with 'Set' operation. Error: time out

occurred." but values will still be successfully set.