Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 424

AlliedView™-EMS 4.0.3 Device Management Guide
Page 424 of 468
Spanning Tree Info
Standard
Displays the port's spanning tree parameters.
Note
- Valid MIB Set values for the Port Path Cost parameter is in the range
[1-65535] inclusive.
Note
- The current firmware version does not allow the Port parameter to
be configured.
Note
- The current firmware version does not allow the Port Priority, Port,
Port Path Cost and Path Cost Contribution parameters to be configured.
Note
- The current firmware version intermittently returns a non-
consecutive order of the port numbering when the XEM module is
interchanged.
Additional Info
Displays additional information on the port's spanning tree parameters.
Note
- The current firmware version does not allow the Protocol Migration
parameter to be set to 'true'.
Note
- The current firmware version does not allow the Point-to-Point
Config parameter to be set to 'auto'.
Note
- Valid MIB Set values for the Port Path Cost Config parameter is [1-
200000000] inclusive. However, the current firmware version allows the
user to set this parameter to '0' as its value and will automatically set the
entered value to valid values.
Note
- The current firmware version does not allow the Protocol Migration,
Edge Port, Point-to-Point Config and Port Path Cost Config parameters to be
configured.
Note
- The current firmware version intermittently returns a non-
consecutive order of the port numbering when the XEM module is
interchanged.
MAC Control Pause
Displays information about the MAC Control Pause function on a single ethernet-
like interface.
Note
- The current firmware version returns a 'noSuchName' value for the Received
Frames (HC) and Transmit Frames (HC) parameters.
Note
- The PAUSE Config parameter is implemented as 'read-only'.