Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 41

AlliedView™-EMS 4.0.3 Device Management Guide
Page 41 of 468
Date and Time
Time Synchronization
Displays the configuration about the device's date/time and time zone.
Note
- Valid MIB Set values for the DST Offset parameter should range from
1-1440. However, the current firmware version allows the user to enter
values outside of the valid range and negative values as well.
Note
- The current firmware version does not allow the DST Start and DST
End parameters to be configured when the DST Mode is set to 'recurring'
or 'date' value.
SNTP/NTP Client Config
Displays information about SNTP/NTP client configuration.
Note
- Valid MIB Set values for the Polling Interval parameter should range
from 60-86400. However, the current firmware version allows the user to
enter values outside of the valid range and negative values as well.
SNTP Config
Displays information about SNTP client configuration.
Broadcast Mode
Displays information about broadcast mode per interface.
Note
- The current firmware version returns a 'noSuchName' value for the
IP Address parameter.
SNTP Server Info
Displays information about trusted SNTP servers to be queried in unicast
or broadcast mode.
Note
- Valid MIB Set values for the Key Identifier parameter is [1-4294967295]
inclusive. However, the current firmware version allows the user to enter
the value '0'.
Authentication Keys
Displays information about keys information for authentication of NTP
packets.
System Log
Basic Info
Displays information and configuration of the device's log files.
Note
- The current firmware version does not allow the Clear Log File and
Clear Cache parameters to be configured.