Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 156)

AlliedView™-EMS 4.0.3 Device Management Guide Page 156 of 468
ISDN
Call Details
Displays ISDN call information such as ISDN number and call direction for
active calls.
Note - The Remote Call parameter does not allow input values that contain
hyphens.
Note - If the In CLI (Calling Line Info) Search parameter is set to 'list', the In
CLI (Calling Line Info) List Check parameter gives the index of the CLI list to
search. The value of CLI list indices ranges from 1 to 100. The value 0 is
returned if the In CLI (Calling Line Info) Search parameter is not set to 'list'.
When the In CLI (Calling Line Info) List Check parameter is set to 0, the In
CLI (Calling Line Info) Search parameter is internally set to 'off'. Subsequently
setting it to a non-zero value will set the In CLI (Calling Line Info) Search
parameter to 'list'. Note that when using the command line interface, CLI List
indices range from 0 to 99, but when using Device Manager, they range from
1 to 100. This is because SNMP will not allow a table index to have the value
0, and the command line usage of indices from 0 to 99 is too well established
to change.
Note - If the In CLI (Calling Line Info) Check parameter is set to 'present' or
'required', the In CLI (Calling Line Info) Check List parameter gives the index
of the CLI list to check against. The value of CLI list indices ranges from 1 to
100. The value 0 means that no list to check against is defined and the check
immediately fails. Note that when using the command line interface, CLI list
indices range from 0 to 99, but when using Device Manager, they range from
1 to 100. This is because SNMP will not allow a table index to have the value
0, and the command line usage of indices from 0 to 99 is too well established
to change.
Note - The PPP Template parameter specifies the PPP template to use when
creating dynamic PPP interfaces for calls generated. The value 33 represents
a default PPP template while the values 1 to 32 represent PPP templates that
are currently defined in the router. Note that when using the command line
interface, PPP template indices range from 0 to 31, but when using Device
Manager, they range from 1 to 32. This is because SNMP will not allow a
table index to have the value 0.
CLI List
Displays the Calling Line Information list.
Active Calls
Displays information about currently active ISDN calls.
Call Log
Displays the call logs.