Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 262

AlliedView™-EMS 4.0.3 Device Management Guide
Page 262 of 468
Note
- When multiple units of the AT-9400 are stacked together, the current
firmware version will always return the value '1' for the Number of Modules
parameter.
Device Info
General Info
Displays general information about the switch.
Note
- L2+ Models: The current firmware version returns an incorrect value
for the RPS Present parameter. If the device is connected to an RPS, the RPS
Present parameter returns 'disconnected'. If it is not, it returns 'connected'.
Note
- The current firmware version does not return the correct value for
the Hardware Version parameter of the following models:
•
AT-9408LC/SP
•
AT-9424T/GB
•
AT-9424T/SP
•
AT-9424Ts
Note
- AT-9424T & AT-9424T/POE: The current firmware version always
returns the value 'on' for the RPS State parameter regardless of its current
state.
Uplink Info
Displays uplink information.
Note
- AT-94xxTs/XP: The current firmware version does not return the
Uplink Info of the XFP port slots with XFP module/s inserted.
Note
- AT-9448Ts/XP: When multiple units of the AT-9400 are stacked
together, the current firmware version intermittently returns values for non-
uplink ports or does not return any values for the Uplink Info parameter.
Temperature Info
Displays temperature information.
Fan Info
Displays fan information.
Note
- AT-9424T/POE: The current firmware version returns a
'noSuchName' value for the Fan Info parameter.
Voltage Info
Displays voltage information.