beautypg.com

Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 423

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 423 of 468

Note

- Device Manager will not display the correct state of the ports and

duplex LEDs if logged-on in SNMPv3 mode using a user account with no read

access to the Interface Info parameters.


Additional Info

Displays port statistics such as the number of frames received and

transmitted on the port, bytes received and transmitted on the port, and

port status.

Note

- The current firmware version returns a 'noSuchName' value for the

following parameters:

Received Bytes (HC)

Received Unicast Packets (HC)

Received Multicast Packets (HC)

Received Broadcast Packets (HC)

Transmitted Bytes (HC)

Transmitted Unicast Packets (HC)

Transmitted Multicast Packets (HC)

Transmitted Broadcast Packets (HC)

Note

- The Promiscuous Mode parameter is implemented as 'read-only'.

Note

- The Counter Discontinuity Time parameter is not applicable to the

SwitchBlade x908 and should be ignored.

Note

- Valid MIB Set values for the Port Alias parameter is up to 64

characters. Attempting to enter values greater than the valid range will be

accepted but values exceeding 64 characters will be truncated.


Error Statistics

Displays error statistics.

Note

- The Ethernet Chipset parameter is not applicable to the SwitchBlade x908

and should be ignored.


Received Address

Displays the address for which the system will accept packets/frames on the

particular interface.

Note

- The Received Address parameter is not applicable to the SwitchBlade x908

and should be ignored.

Note

- The Received Address Status and Received Address Type parameters are

implemented as 'read-only'.